Connecting Prospeo

Connect Prospeo to use it as a provider in the waterfall email finder. Once connected, Prospeo runs as part of your provider sequence at no platform credit cost — using your Prospeo subscription instead.

Written By Kevin Lawrie

Last updated About 23 hours ago

What this integration does

Prospeo is an email finder provider. Connecting it adds it to your waterfall email finder sequence, where it can find and verify email addresses for enriched contacts using your existing Prospeo subscription credits.

Platform credit cost when using Prospeo: -0 credits per email found.

Connecting Prospeo

  1. Go to Integrations in the left sidebar.

  2. Find Prospeo and click Configure.

  3. Enter your Prospeo API key.

  4. Click Save to connect.

Find your API key in your Prospeo account settings.

Using Prospeo in the email finder waterfall

Once connected, Prospeo appears as an available provider in the Email and Mobile Finder block on any Signal's Configure step, and in the Find Email action in the Contacts manager.

To activate it:

  1. Open the Email and Mobile Finder block.

  2. Find Prospeo in the available providers list.

  3. Click Enable to add it to your sequence.

  4. Drag it to your preferred position — providers higher in the sequence are tried first.

The waterfall tries each enabled provider in order and stops as soon as a verified email is found. If Prospeo is first in the sequence, it runs before any other provider and its credits are used instead of platform credits.

See [Waterfall Email Finder] for full details on configuring and optimising your provider sequence.

When to use Prospeo vs getsignals(in)

If you already have an active Prospeo subscription, connecting it and moving it to the top of the waterfall sequence is the most cost-efficient setup — you use your existing subscription rather than spending platform credits. The getsignals(in) built-in finder then acts as a fallback for any contacts Prospeo can't find.